I thought I worked out what you were building, some top and bottom firing cabinets with a horn in the middle, but now I'm befuddled again. It's been a long time since your last back operation, just wondering if you are working towards another one ?
Twodogs said:
I thought I worked out what you were building, some top and bottom firing cabinets with a horn in the middle, but now I'm befuddled again. It's been a long time since your last back operation, just wondering if you are working towards another one ?
trouble with the vertical grain sheets is there 1200mm wide so I wouldn't get enough of a wrap around and could end up having 2 joins right on the sides of the cabinets .
I have been looking at 3M film wraps . They do need to be applied onto a high gloss finish . I you do get shrinkage under the film it will show through .
Comments
My fav epoxy , Megapoxy 69 . This has great vertical hold & a work time of 45min @ 25 0c .
First layer , the shiny service is stretch wrap so the straps don't get glued to the cab's .
Cheers
P.S No mop needed to clean the floor of glue
Very cool
We/I need more info...
How did you apply it? Spray? What size nozzle?
What colour is it?
Can it be used as a covering as well as a glue?
How much is it?
I just need to add...
Not a bad job, for a crip & a salesman.
no hurry Mal...
Found it!
http://megapoxy.com/wp-content/uploads/Megapoxy69.pdf
$180 for the 4 Lt kit
I used a scrapper 80mm to apply the epoxy
2nd one done
Cheers
I thought I worked out what you were building, some top and bottom firing cabinets with a horn in the middle, but now I'm befuddled again. It's been a long time since your last back operation, just wondering if you are working towards another one ?
2 back ops are enough
Top & bottom firing :-O
How many joins top to bottom?
1st layer
3 joins ,so each sheet ended up half way on a brace .
2nd & 3rd layer
2 alternating joins , 1200mm @ bottom ,600mm @ top vise versa
4th layer not decided ,might go with a vertical long grain sheet ?
Cheers
Trees grow vertical.
I reckon, if possible, last sheet should be vertical grain.
trouble with the vertical grain sheets is there 1200mm wide so I wouldn't get enough of a wrap around and could end up having 2 joins right on the sides of the cabinets .
Vinyl wrap?
[runs away]
I have been looking at 3M film wraps . They do need to be applied onto a high gloss finish . I you do get shrinkage under the film it will show through .
Yeah, I get that.
But it doesn't normally show through. X_X
On cars or speaker cabs with joins?
Oh, I thought we were talking about penile dysfunction.
...which doesn't show through
:-??
petrified wood shows through.
yours is petrified because your choices are such good lookers! :-O