Everyone can now send invitations! Please read the guidelines. And then send your invitations.

How to cut square holes

edited December 2013 in Audio Projects

I finally figured out how to get a neat square(ish) hole! All you need is one of these:

http://www.carbatec.com.au/pattern-following-bit_c9470

I don't have that exact one but same type of thing. To start with I used an "L" made from two pieces of scrap as a template, not perfect results but better (and quicker) than before:

1312b-0001

Unfortunately I stuffed up adding roundovers to some of these pieces (that was supposed to be the easy part!) which triggered a bit of a rethink on the design of the panels, will try again tomorrow.

Comments

Sign In or Register to comment.